Overhang clip-A gold tool that ties the wire and hangs at the end of the overhang insulator string or from the pole tower.

The clip is a gold or piece that is secure to the wire.

The above definition indicates that “wire clip” can be a separate gold ware, such as trench clip, damping clip, etc., or gold

parts, such as vibration hammer clip, spacer clip, etc.However, the fundamental difference between it and the overhang

clamp is still different from the design principle, with the certain curvature radius of the line groove part of the overhang

clamp, while there is no such requirement for the line clamp.Therefore, another gold product, “jumper overhanging clamp”,

because its name stipulates that it can only be used on the jumper, this product can be made of overhang clamps or wire

clips (no radius of curvature).

1.2 Structural components of the overhang wire clip

The standard overhang clip consists of four parts, hull, rotary shaft, hanger (ear) and fastening device are not described.

Since the performance requirements of breeze vibration are a key design principle of the cantilever clip, according to the

relative position relationship between the swing shaft and the wire axis, the cantilever clip can be divided into: upper carry,

center swing and bag type.Nor is the definition stated here.

1.3 Gripping characteristics of the overhang clamp

According to the overhang clamp, it needs to tighten the wire to produce a certain grip strength, which is done by the fastener

in the wire clamp structure, and the standard suspension clamps is composed of pressure bars and screws.The grip strength

produced by overhang clamp can be divided into the following types and become a design principle of overhang clamp.

The fixed one only has the specified minimum grip value, where the wire cannot slide online; the maximum grip value of the

wire clip is not specified, but against the mechanical strength of the wire.

The sliding type one only has the specified maximum grip force value, and the wire shall slide in the online clip before reaching

this grip force value.

The limited grip type has a specified minimum grip value where the wire cannot slide online, with the specified maximum grip

value, and the wire shall slide in the online grip.That is, between the minimum and the maximum, sliding must appear in the

wire clip.